ISO INTERNATIONAL STANDARD 25639-2 First edition 2008-11-15 Exhibitions, shows, fairs and conventions - Part 2: Measurement procedures for statistical purposes Terminologie du secteur des foires, salons et congres ou manifestations commerciales Partie 2: Methodes de comptage a des fins statistiques Reference number ISO 25639-2:2008(E) @ ISO 2008 ISO 25639-2:2008(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The Iso Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation COPYRIGHT PROTECTED DOCUMENT ? ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland = Provided bv IHS under license with ISO ISO 2008-All rights reserved ISO 25639-2:2008(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnical committeehasbeen non-governmental, in liaison with Iso, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 25639-2 was prepared by Project Committee ISO/PC 237, Exhibition terminology. Iso 25639 consists of the following parts, under the general title Exhibitions, shows, fairs and conventions: Part 1: Vocabulary Part 2: Measurement procedures for statistical purposes @ IS0 2008 - All rights reserved ii